A NEW LOOK AT FLOOD RISK DETERMINATION1

ABSTRACT: The probability distributions of annual peak flows used in flood risk analysis quantify the risk that a design flood will be exceeded. But the parameters of these distributions are themselves to a degree uncertain and this uncertainty increases the risk that the flood protection provided will in fact prove to be inadequate. The increase in flood risk due to parameter uncertainty is small when a fairly long record of data is available and the annual flood peaks are serially independent, which is the standard assumption in flood frequency analysis. But standard tests for serial independence are insensitive to the type of grouping of high and low values in a time series, which is measured by the Hurst coefficient. This grouping increases the parameter uncertainty considerably. A study of 49 annual peak flow series for Canadian rivers shows that many have a high Hurst coefficient. The corresponding increase in flood risk due to parameter uncertainty is shown to be substantial even for rivers with a long record, and therefore should not be neglected. The paper presents a method of rationally combining parameter uncertainty due to serial correlation, and the stochastic variability of peak flows in a single risk assessment. In addition, a relatively simple time series model that is capable of reproducing the observed serial correlation of flood peaks is presented.     

GEOLOGIC INFERENCE FROM “FLOW NET” TRANSMISSIVITY DETERMINATION: THREE CASE STUDIES1

A graphical inverse method for determining the regional transmissivity distribution was applied to three field problems. The study areas were the Hanford Site, Washington; the Rocky Mountain Arsenal, Colorado; and the Nevada Test Site, Nevada. This method can aid in flow system conceptualization by revealing the location of bedrock controls for groundwater flow. It is a valuable tool for aiding the hydrogeologist in asking questions about the nature of trends in the pattern of transmissivity values. Quantitative estimates of regional transmissivities can be used as starting points for further parameter refinement. Sensitivity analysis using Monte Carlo simulation shows that quantitative estimates of transmissivity can be obtained when measurement error in the hydraulic head does not cause a large error in the hydraulic gradient.     

PARAMETRIC ESTIMATION OF COVARIANCES OF REGIONALIZED VARIABLES1

ABSTRACT: The usefulness of stochastic models in describing the spatial variability of hydrogeologic quantities, such as permeability, storativity, piezometric head, seepage velocity, and solute concentrations is now widely recognized. In practice, these quantities are represented as the sum of a well-structured component, or drift, and a more erratic fluctuation component which is described statistically through its covariance function. This paper reviews some of the most recent and most promising methods for the estimation of parameters of these covariances from existing data. They are maximum likelihood, restricted maximum likelihood, minimum-variance unbiased quadratic estimation, and minimum-norm (weighted least squares) estimation. The applicability of such methods to conditional and unconditional probability problems is discussed.     

IDENTIFICATION OF AQUIFER DISPERSIVITIES: METHODS OF ANALYSIS AND PARAMETER UNCERTAINTY1

ABSTRACT: This paper presents a method for estimating aquifer dispersivities in solute transport models. Sensitivity equations are derived for the calculation of sensitivity coefficients. A modified Gauss-Newton algorithm is used to perform the least-squares minimization. A statistical procedure is outlined to assess reliability of the estimated parameters. The solute transport model is solved by the upstream weighted, multiple cell balance method which combines the concepts of local mass balance and finite element approximations. A one-dimensional solute transport problem in a vertical column system is first used to illustrate the inverse technique. A second example considers the parameter identification problem for three-dimensional solute transport with a unidirectional steady and uniform flow field. The third example solves the parameter identification problem in a three-dimensional, stream-aquifer, solute transport system with steady state flow. Numerical experiments are conducted to study data requirements for parameter identification.     

KRIGED ESTIMATES OF TRANSMISSIVITY IN THE MESILLA BOLSON,NEW MEXICO1

ABSTRACT: Kriging utilizes a statistically based procedure of spatial interpolation that incorporates the spatial correlation structure of the phenomenon, and provides an error estimate. Kriging was applied to a total of 141 transmissivity values in an attempt to quantify the transmissivity distribution of the Santa Fe aquifer in Mesilla Bolson. New Mexico. The analysis produced contour maps of estimated transmissivity values and associated estimation variances. Through variogram analysis and fitting of an exponential variogrsm to 141 natural log of transmissivity (InT) values, the range was determined to be 3 miles, the average variance 2.74 (σ_InT= 1.65) with a mean of 8.65. Kriged estimates were generally lower when compared to estimates based on available transmissivity maps.     

城市生活垃圾综合处理前分选系统设计

本文以江油市城市生活垃圾处理厂为工程实例,介绍了垃圾前分选系统中的垃圾储料车间、行车与抓斗、垃圾上料机构、双层振动筛以及人工分选平台的工艺设计参数及设计依据,并在此基础上提出了该系统的改进建议.     

大气污染与平流层气溶胶

本文简述了大气污染与气溶胶的关系，论述了平流层气溶胶对地球辐射收支的影响，从而说明平流层气溶胶的光学性质的变化将影响全球大气环境，在此基础上，计算了不同背景平流层气溶胶的光学常数和光学特性参数。并使用模式光学常数计算了３种火山模工气溶胶的光学特性参数。同时，考察了这些特性参数对光学常数的敏感性。结果表明，后向散射系数对光学常数的变化最敏感，对于某些波长，它的相对变化可比光学常数的相对变化大一个数量     

DEVELOPMENT OF WATERSIIED MODELS FOR TWO SIERRA NEVADA BASINS USING A GEOGRAPHIC INFORMATION SYSTEM1

ABSTRACT: Techniques were developed using vector and raster data in a geographic information system (GIS) to define the spatial variability of watershed characteristics in the north-central Sierra Nevada of California and Nevada and to assist in computing model input parameters. The U.S. Geological Survey's Precipitation-Runoff Modeling System, a physically based, distributed-parameter watershed model, simulates runoff for a basin by partitioning a watershed into areas that each have a homogeneous hydrologic response to precipitation or snowmelt. These land units, known as hydrologic-response units (HRU's), are characterized according to physical properties, such as altitude, slope, aspect, land cover, soils, and geology, and climate patterns. Digital data were used to develop a GIS data base and HRIJ classification for the American River and Carson River basins. The following criteria are used in delineating HRU's: (1) Data layers are hydrologically significant and have a resolution appropriate to the watershed's natural spatial variability, (2) the technique for delineating HRU's accommodates different classification criteria and is reproducible, and (3) HRU's are not limited by hydrographic-subbasin boundaries. HRU's so defined are spatially noncontiguous. The result is an objective, efficient methodology for characterizing a watershed and for delineating HRU's. Also, digital data can be analyzed and transformed to assist in defining parameters and in calibrating the model.     

DETERMINING SIGNIFICANCE AND PRECISION OF ESTIMATED PARAMETERS FOR RUNOFF FROM SEMIARID WATERSHEDS1

ABSTRACT Significant parameters for predicting thunderstorm runoff from small semiarid watersheds are determined using data from the Walnut Gulch watershed in southern Arizona. Based on these data, thunderstorm rainfall is dominant over watershed parameters for predicting runoff from multiple linear regression equations. In some cases antecedent moisture added significantly to the models. A technique is developed for estimating precision of predicted values from multiple linear regression equations. The technique involves matrix methods in estimating the variance of mean predicted values from a regression equation. The estimated variance of the mean predicted value is then used to estimate the variance of an individual predicted value. A computer program is developed to implement these matrix methods and to form confidence limits on predicted values based on both a normality assumption and the Chebyshev inequality.     

Short-term wind speed forecasting based on random forest model combining ensemble empirical mode decomposition and improved harmony search algorithm

ABSTRACT

Wind speed forecasting plays an important role in power grid dispatching management. This article proposes a short-term wind speed forecasting method based on random forest model combining ensemble empirical modal decomposition and improved harmony search algorithm. First, the initial wind speed data set is decomposed into several ensemble empirical mode functions by EEMD, then feature extraction of each sub-modal IMF is performed using fast Fourier transform to solve the cycle of each sub-modal IMF. Next, combining the high-performance parameter optimization ability of the improved harmony search algorithm, two optimal parameters of random forest model, number of decision trees, and number of split features are determined. Finally, the random forest model is used to forecast the processing results of each submodal IMF. The proposed model is applied to the simulation analysis of historical wind data of Chaoyang District, Liaoning Province from April 27, 2015 to May 22, 2015. To illustrate the suitability and superiority of the EEMD-RF-IHS model, three types of models are used for comparison: single models including ANN, SVM, RF; EMD combination models including EMD-ANN, EMD-SVM, EMD-RF; EEMD combination models including EEMD-ANN, EEMD-SVM, EEMD-RF. The analysis results of evaluation indicators show that the proposed model can effectively forecast short-term wind data with high stability and precision, providing a reference for forecasting application in other industry fields.